Hepco & Becker NOVA Universal LED Auxiliary Light Kit
Improve lighting conditions with the LED Flooter Lights from Hepco & Becker! Extra lighting and visibility is essential to safety. These lights consist of 3 high power LEDs with a 12-volt current and are housed in an aluminum shell. This kit consists of a complete set being two lights, a switch, a wiring harness, mounting material, and housing protection.
The fog lights are universally mounted. The most common way to mount them is on crash guards or other tubular parts of the bike. The tube clamps are for sizes 22-47mm in diameter. This is suitable for almost any crash guard out there including the Hepco and Becker engine and tank gaurds.
- High-power LEDs with two switching levels at 2,500lm - 4350K / 5500K
- 12 volts, per headlight 22 watts
- ECE tested and approved, therefore no individual approval is required (observe country-specific legal
- regulations for installation)
- Improved traffic light conditions
- Universal attachment to engine or tank protection bar with tube Ø18mm – Ø25mm, can be attached standing or hanging
- Complete headlight set; Incl. 2x LED additional headlights, 1x switch, 1x cable set, 2x clamp incl. reducing sleeves, 1x instructions, 1x tool set
- Connection is only via the battery, no connection to the vehicle wiring harness is required
- No external operation by third parties, thanks to a special control unit with automatic voltage control
- Waterproof and dustproof to IP67
- Headlights can be flexibly switched on using the switch on the handlebars
Note: The lights can only be switched on approx. 5-15 seconds after the engine has been started. A voltage of 13.1 V must be applied to the control unit of the wiring harness to enable the circuit. In older vehicles, this can be achieved by briefly increasing the engine speed. Switching off must be done manually using the switch. The NOVA LEDs continue to light up until the voltage limit of 11.3 V is reached, even after the engine is switched off. Only when the voltage falls below this limit do the lights switch off automatically via the control unit. When switching on again (wait for the time limit of control unit), the voltage limit of 13.1 V is queried again.
| ExtraField1 | Black |
|---|---|
| upc | 731.107 |
| Brand | Hepco & Becker |
| Fitment | Universal |
| Product | All Lighting |
| Description | Improve lighting conditions with the LED Flooter Lights from Hepco & Becker! Extra lighting and visibility is essential to safety. These lights consist of 3 high power LEDs with a 12-volt current and are housed in an aluminum shell. This kit consists of a complete set being two lights, a switch, a wiring harness, mounting material, and housing protection. The fog lights are universally mounted. The most common way to mount them is on crash guards or other tubular parts of the bike. The tube clamps are for sizes 22-47mm in diameter. This is suitable for almost any crash guard out there including the Hepco and Becker engine and tank gaurds.
Note: The lights can only be switched on approx. 5-15 seconds after the engine has been started. A voltage of 13.1 V must be applied to the control unit of the wiring harness to enable the circuit. In older vehicles, this can be achieved by briefly increasing the engine speed. Switching off must be done manually using the switch. The NOVA LEDs continue to light up until the voltage limit of 11.3 V is reached, even after the engine is switched off. Only when the voltage falls below this limit do the lights switch off automatically via the control unit. When switching on again (wait for the time limit of control unit), the voltage limit of 13.1 V is queried again. |
