Pyramid Plastics Extenda Fenda Triumph Tiger 900 Rally / Rally Pro 2020-

Ive had this product on a R1200GS and was very pleased.
Make sure you note GT vs. Rally Pro as the fit is different.
Motomachines graciously swapped for me.

This was a great solution for protecting my Tiger 900 from stones! Easy set up, remove the fender to set the glue pads with clamps. I didn't need to use the provided rivets (didn't feel like drilling holes in my fender). The fender extender held up great therough the Mid-Atlantic BDR and beyond!

The fit is perfect, look great and easy to install

It fit very well and works great. I used 4 small screws along with the double sided tape just to make sure it stays on long term.
Note the GT and the Rally use different ones, so make sure to specify your bike...

Best to remove from fender. I used the plastic pop rivets with some of the adhesive. Clean the plastic contact surfaces as instructed, attache adhesive to to hold in place drill holes and insert pop rivets.
Fit very well and long enough to keep excess road spray off the engine.

Install was a breeze with the adhesive sticky pads, even without removing front fender. Surface finish and texture complements the stock fender. @Tiger2Up

This is what I needed to reduce dirt/mud spray onto the engine front. Also reduces dirt and dust coming up into the rider compartment from the space between the forks and the tank. Easy to install. Take the fender off to make it much easier to install.

This is my third F-E purchase. They work as advertised,
look great, stick well, easy install.

Fits perfectly. Goes on securely. Performs as advertised.

Solid construction, style blends in well with OEM finder, works as promised and relatively low cost. Helps reduce mud and dirt splatter on my 2021 Triumph Tiger Rally Pro.

This extension is great, easy to install and accomplish its function very well

I had one of these on my 2013 Tiger Explorer. It did the job and so does the new one on my Tiger 900 RP.

Fits well, taking of the mudguard to mount it is not difficult, easy upgrade.

Easy to install and works well so far.

Purchased to reduce chances of wheel debris getting to the radiator. Installed easily but not quite straight. In hindsight I should have positioned the fenda without the adhesive pads and use two or three pieces of masking tape on the underside to hold it in place. Hinge the fenda back (without disturbing the masking tape) and apply the adhesive pads. Again, hinge the fenda back into place letting the masking tape guide the two pieces back into place. The instructions provide for a metric drill bit however it was no issue to convert.

This is a nice addition to the front fender. Should keep the header cleaner.
Easy installation, great fit, and finish.

Easy install and hope to save the crud on the bike with this